Fibaro Z-Wave Dimmer Bypass
This Fibaro Bypass acts as a dummy load and increases the load above the 25W minimum required by the Fibaro dimmer. Eliminate the flickering and light constantly on associated with insufficient load on the circuit.
Fibaro Z-Wave Dimmer Bypass (For use only with Dimmer v1)
All z-wave dimmers require a minimun load on the light circuit otherwise it may not work. The Fibaro dimmer is the best for low load light circuits and requires a minimum load of 25W however if you use it on a circuit with a load less than this you may encounter flickering and lights refusing to switch on or off.
This Fibaro Bypass acts as a dummy load and increases the load above the 25W minimum to eliminate these issues.
♦ Only use with the Fibaro Dimmer module.
♦ Supports low-power lamps such as LEDs
♦ Fits into wall socket alongside the Dimmer module or inside the light fitting
♦ Easy installation by electrican
Repeats z-wave signals | Yes |
---|---|
DIY | No |
Electrican Required | Yes |
Neutral wire requirement | No |